Morley Fire Panels Installation Manual - Smiths Technical Systems
Morley Fire Panels Installation Manual - Smiths Technical Systems
Morley Fire Panels Installation Manual - Smiths Technical Systems
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
ZX <strong>Fire</strong> Alarm Control <strong>Panels</strong> MORLEY-IAS<br />
3.5 Installing Additional Equipment<br />
3.5.1 General Introduction<br />
Always ensure that the mains and battery power supplies have been isolated before<br />
plugging or unplugging any of the internal circuit boards.<br />
Follow the specific instructions supplied with each item of additional equipment.<br />
At least one loop driver board MUST be installed for the unit to operate as a <strong>Fire</strong> Alarm<br />
Control Panel.<br />
• The following diagrams show the locations for installing additional equipment onto the base card.<br />
3.5.1.1 ZX1Se Arrangement<br />
RS485<br />
Interface<br />
Card<br />
PORT C<br />
RS485 or RS232<br />
Interface Card<br />
Figure 27 – Positions for Additional Boards – ZX1Se<br />
Loop Driver<br />
Module<br />
<strong>Installation</strong> <strong>Manual</strong> Document No. 996-174-000-1, Revision: 01 Page 27