Morley Fire Panels Installation Manual - Smiths Technical Systems
Morley Fire Panels Installation Manual - Smiths Technical Systems
Morley Fire Panels Installation Manual - Smiths Technical Systems
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
MORLEY-IAS ZX <strong>Fire</strong> Alarm Control <strong>Panels</strong><br />
EN54<br />
!<br />
EN54-2 12.5.2<br />
Maximum of 32<br />
sensors / MCP’s<br />
between Isolators.<br />
For best results and system integrity:<br />
The detection loop circuit should be wired as a loop with short circuit<br />
isolators. This allows the system to still function in the event that a<br />
section of the cable becomes short-circuited. It is recommended that<br />
short-circuit isolators be fitted to the detection loop to prevent an<br />
external short circuit from removing more than 32 addressable points<br />
from the system.<br />
• The detection loop connections are made on the terminal blocks at the top of the base card.<br />
3.4.3.1 Loop Wiring <strong>Installation</strong><br />
• Form the loop by taking wires from<br />
the positive and negative terminals,<br />
at one side of the connector on the<br />
base card – see opposite.<br />
• Proceed with installing wiring,<br />
around the loop, connecting all<br />
devices – see below.<br />
• Return the wiring to the positive and<br />
negative terminals at the other side<br />
of the connector on the base card.<br />
• Ensure that all devices connected to<br />
the loop are correctly oriented for<br />
positive and negative connections.<br />
• Refer to the detector manufacturers’<br />
data sheet supplied with the<br />
signalling device.<br />
FACP Connections<br />
Data / Power (+) OUT<br />
Data / Power<br />
(-) OUT<br />
Data / Power<br />
(+) RETURN<br />
Data / Power<br />
(-) RETURN<br />
Data / Power (+) OUT<br />
Data / Power (-) OUT<br />
Figure 10 – Loop Wiring without Isolators<br />
Figure 9 – SLC Connections<br />
(+) RETURN<br />
(-) RETURN<br />
Page 14 Document No. 996-174-000-1, Revision: 01 <strong>Installation</strong> <strong>Manual</strong>