Intermittent Torch Ignition - Torchmate
Intermittent Torch Ignition - Torchmate
Intermittent Torch Ignition - Torchmate
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
with thicker material uses. Testing of the delay may be necessary to find the timing that<br />
works best for your material. Proximity Sensors are utilized to measure the distance<br />
from the material you are cutting. This delay in this case should be set to 4 seconds to<br />
allow for consistent reading of the material before the plasma creation is initiated.<br />
In all cases the M code 51 setting should be set in a range from 1 to 1.5 seconds, to<br />
allow for air to wash over the consumables in an effort to cool them, prior to the next<br />
torch cutting sequence.<br />
Troubleshooting<br />
If the air comes on prior to a torch ignition, but the torch does not fire, check to see if<br />
there are any warning lights flashing or continuously lit which are displaying a<br />
malfunction on your plasma unit. If so, check your plasma unit’s manual for<br />
troubleshooting help, or call the Technical Support of the manufacturer for preventive<br />
and/or corrective measures.