Ethernet Configuration and Control, cont'd - Extron Electronics
Ethernet Configuration and Control, cont'd - Extron Electronics
Ethernet Configuration and Control, cont'd - Extron Electronics
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
PRELIMINARY<br />
<strong>Ethernet</strong> <strong>Configuration</strong> <strong>and</strong> <strong>Control</strong>, cont’d<br />
4-12<br />
Daylight Savings: Daylight savings time (DST) is a one-hour offset that<br />
is observed in some countries. You can select one of the radio buttons to<br />
set the PC1 for daylight savings time for the U. S., Europe, or Brazil; or<br />
select Off to disable it. The following daylight savings periods are<br />
observed:<br />
U. S. — Starts the second Sunday in March <strong>and</strong> ends the first<br />
Sunday in November. (Daylight saving time should be turned off<br />
in Hawaii, American Samoa, most equatorial regions, Guam,<br />
Puerto Rico, the U. S. Virgin Isl<strong>and</strong>s, eastern time zone portion of<br />
the state of Indiana, <strong>and</strong> the state of Arizona (excluding the Navajo<br />
Nation).<br />
Europe — Starts the last Sunday in March <strong>and</strong> ends the last<br />
Sunday in October. (Daylight saving time should be turned off in<br />
Icel<strong>and</strong>.)<br />
Brazil — Starts the first Sunday in October <strong>and</strong> ends the third<br />
Sunday in February. (Daylight saving time should be turned off in<br />
equatorial Brazil.)<br />
3. When you have made all the desired changes in the Date/Time Settings<br />
section, click the Submit button at the bottom of the section. The new date<br />
<strong>and</strong> time settings are displayed in the fields in which you entered them.<br />
If you want to discard your new entries without submitting them <strong>and</strong> restore<br />
the previous settings, click Cancel (do not click Submit).<br />
Configuring the RS-232 port <strong>and</strong> the AC receptacle<br />
The Port & AC Settings screen on the <strong>Configuration</strong> tab enables you to specify<br />
settings for the RS-232 port <strong>and</strong> the rear panel AC receptacle.<br />
Port & AC Settings screen<br />
Contact input port<br />
This field shows the status of the contact input port. If On is selected, the contact is<br />
closed (connected to ground). If Off is selected, the contact is open (not connected<br />
to ground).<br />
IPL T PC1 <strong>Ethernet</strong> <strong>Configuration</strong> <strong>and</strong> <strong>Control</strong><br />
You cannot make changes in this field; it only reflects the condition of the port.