Ethernet Configuration and Control, cont'd - Extron Electronics
Ethernet Configuration and Control, cont'd - Extron Electronics
Ethernet Configuration and Control, cont'd - Extron Electronics
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Reduced air flow — Installation of the equipment in a rack should be such<br />
that the amount of air flow required for safe operation of the equipment is not<br />
compromised.<br />
Mechanical loading — Mounting of the equipment in the rack should be such<br />
that a hazardous condition is not created due to uneven mechanical loading.<br />
Circuit overloading — Consideration should be given to the connection of the<br />
equipment to the supply circuit <strong>and</strong> the effect that overloading of the circuits<br />
might have on overcurrent protection <strong>and</strong> supply wiring. Appropriate<br />
consideration of equipment nameplate ratings should be used when<br />
addressing this concern.<br />
Reliable earthing (grounding) — Reliable earthing of rack-mounted<br />
equipment should be maintained. Particular attention should be given to<br />
supply connections other than direct connections to the branch circuit (e.g.<br />
use of power strips.<br />
Rack mounting procedure<br />
To mount the PC1 on a rack shelf,<br />
1. If rubber feet have been installed on the bottom of the unit, remove them.<br />
2. Mount the PC1 on the rack shelf, using two 4-40 x 3/16" screws in opposite<br />
(diagonal) corners of the unit to secure it to the shelf.<br />
3. Attach a blank panel or other unit(s) to the rack shelf.<br />
RSU 129<br />
1U Universal Rack Shelf<br />
Both front false faceplates<br />
use 2 screws.<br />
Use 2 mounting holes on<br />
opposite corners.<br />
1/2 Rack Width Front False<br />
Faceplate<br />
1/4 Rack Width Front False<br />
Faceplate<br />
(2) 4-40 x 3/16"<br />
Screws<br />
Mounting the IPL T PC1 on an RSU 129 Universal rack shelf<br />
4. Insert the shelf into the rack, aligning the holes in the shelf with those in the<br />
rack.<br />
5. Secure the shelf to the rack using the supplied machine screws. This shelf can<br />
be mounted in the front or in the rear of the rack.<br />
IPL T PC1 Installation <strong>and</strong> Rear Panel<br />
2-3<br />
PRELIMINARY