ECOR264- DVR manual-4605XCOR04004AR - Everfocus
ECOR264- DVR manual-4605XCOR04004AR - Everfocus
ECOR264- DVR manual-4605XCOR04004AR - Everfocus
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
ATTENTION: EDA997A signal distributors are unidirectional! This means that the signal only flows from<br />
the input towards the outputs. Therefore, e.g. the interconnection of several keyboards is not possible with<br />
these types of signal distributor!<br />
1.9.2 RS-485 socket pin assignment<br />
The RS485 pin assignment is as follows:<br />
+<br />
I<br />
1.9.3 EKB-500 connection with network patch cable<br />
For a simple, short distance installation, recorder and keyboard can be connected directly using a standard<br />
CAT5 network cable with an 8-pin connector at only one end, and at the other end the Pin 3 wire connected<br />
to RS485 “+” (plus) and the pin 6 wire connected to RS-485 “-“ (minus).<br />
1.9.4 EKB-500 connection to several <strong>DVR</strong>s<br />
For long distance installations connecting several <strong>DVR</strong>s, please use an EDA997A signal distributor to<br />
connect. For further details on keyboard connection, please refer to the EKB-500 <strong>manual</strong>.<br />
RS-485 port communication settings are configured in the I/O CONTROL menu (Section 5.10.4 System<br />
Setup: I/O - control).<br />
1.9.5 Speed Dome Installation<br />
Speed dome or telemetry receiver pan/tilt/zoom control is available through web browser or the optional<br />
PowerCon software if the <strong>DVR</strong> is connected to a network. Local telemetry control is provided by USB -<br />
mouse control or by the optional EKB-500 keyboard.<br />
Supported protocols: EverFocus, Pelco-D, Pelco-P, Samsung, Transparent<br />
Required <strong>DVR</strong> settings: RS-485 receiver address in CAMERA menu<br />
(Section 4.3)<br />
RS-485 parameters and protocol in the I/O CONTROL menu<br />
(Section 5.10.4)<br />
12