EDR810H/EDR810M EDR410H/EDR410M - EverFocus

3.5 Motion Setup Menu
Diagram 3.8
Diagram 3.8 is a screen shot of the MOTION SETUP MENU. We define motion as a change of
pixilation in the field of view, which is detected by the digital video recorder, and triggering the
recorder to start recording. Motion is also considered an event. This menu is for setting up the digital
recorder for motion recording on a per camera basis. In the MOTION SETUP MENU the following
fields are defined as follows:
1. MOTION: This field is to turn motion recording on or off. The Default from the factory is set to
off or disabled. To change this, simply use the Jog Dial on the DVR.
ENABLE: Enable motion detection.
DISABLE: Disable motion detection.
Note: Motion only works in live and playback modes. It is invalid while in menus.
2. SENSITIVITY: The sensitivity allows users to adjust to a suitable motion detection sensitivity.
There are 10 sensitivities available; level 1 is the lowest, and level 10 is the highest. The default is 7.
To change this, simply use the Jog Dial on the DVR.
3. LOG:
ON: Select ON if you wish to record Motion Events in the Log.
OFF: Select OFF if you do not wish to record Motion Events in the Log.