- Page 1 and 2:
Instruction Manual EDR810H/EDR810M
- Page 3:
Federal Communication Commission In
- Page 6 and 7:
4.2 SCHEDULE RECORDING SETUP.......
- Page 8 and 9:
Safety Warning WARNING TO REDUCE RI
- Page 10 and 11:
Safety Precautions Read Instructio
- Page 12 and 13:
1.2 Specifications Video format NTS
- Page 14 and 15:
9 FULL: Press this key and channel
- Page 16 and 17:
1.4 Back Panel Connections Back pan
- Page 18 and 19:
LAN 7 LAN Connector: RJ-45 network
- Page 20 and 21:
1 Channel tag: A channel tag indica
- Page 22 and 23:
3. Event The current/last event tha
- Page 24 and 25:
2.1 Basic Wiring Instructions Pleas
- Page 26 and 27:
2.2 Hard Disk Drive Installation Th
- Page 28 and 29:
Unpack Everything Make sure you hav
- Page 30 and 31:
Possible Installation Locations Ins
- Page 32 and 33:
3. DVR Menu Setup Assuming you have
- Page 34 and 35:
5. DAYLIGHT SAVING: This field repr
- Page 36 and 37:
Alaska Standard Time subtract 9 hou
- Page 38 and 39:
4. SEQ (MAIN/CALL): Set the number
- Page 40 and 41:
7. SUMMARY: Diagram 3.5 Dial Jog to
- Page 42 and 43:
4. WATER MARK: ON: Recording is ove
- Page 44 and 45:
3. LOG: ON: Select ON if you wish t
- Page 46 and 47:
3.5 Motion Setup Menu Diagram 3.8 D
- Page 48 and 49:
To edit a MOTION AREA, enter a desi
- Page 50 and 51:
5. ALARM EMAIL: Select “YES” fo
- Page 52 and 53:
2. IP Address This field shows the
- Page 54 and 55:
3.7.2 ALARM NETWORK DVR can send ou
- Page 56 and 57:
7. SENDER EMAIL ADDR Input sender
- Page 58 and 59:
Shared: need shared key. WEP: uses
- Page 60 and 61:
3.7.7 DDNS In DDNS of the NETWORK S
- Page 62 and 63:
3.7.8 GPS In GPS of the NETWORK SET
- Page 64 and 65:
3. END: This field is used to set t
- Page 66 and 67:
2. THERMOMETRIC SCALE: Select CELSI
- Page 68 and 69:
RS485: 5. RS485 Baud Rate: This fie
- Page 70 and 71:
4. NETWORK ALARM: YES: To enable ne
- Page 72 and 73:
3.11.3 NO HDD In NO HDD, we define:
- Page 74 and 75:
4. NETWORK ALARM: YES: To enable ne
- Page 76 and 77:
4. UPDATE SYSTEM SOFTWARE: Turn the
- Page 78 and 79:
4. Recording Overview Before contin
- Page 80 and 81:
4.3 Event Recording Setup We will d
- Page 82 and 83:
Note: 1. If you only want to record
- Page 84 and 85:
(3) Fast Forward/Reverse Playback P
- Page 86 and 87:
5.2 Search Playback SEARCH Press th
- Page 88 and 89: The event types and number show on
- Page 90 and 91: In the COPY MENU, we define: Diagra
- Page 92 and 93: 7. Call Overview This chapter will
- Page 94 and 95: When turning SHARPNESS OFF, the ima
- Page 96 and 97: 09 10. Networking Overview This cha
- Page 98 and 99: Note: Everfocus suggests having a m
- Page 100 and 101: 10.7 Simple One to One Connection C
- Page 105 and 106: Once you have reached this point cl
- Page 107 and 108: Now Log into the EverFocus DVR menu
- Page 109 and 110: Connection Procedure: The First st
- Page 111 and 112: 11. Linksys Port Forwarding Chapter
- Page 113 and 114: application. Enable - Click the Ena
- Page 115 and 116: 12. D-Link Port Forwarding Chapter
- Page 117 and 118: Name - Enter the name referencing t
- Page 119 and 120: 13. EverFocus DDNS Setup Note: You
- Page 121 and 122: 14. Viewing through Internet Explor
- Page 123 and 124: Click the Security tab at the top,
- Page 125 and 126: The followings are a brief descript
- Page 127 and 128: 14.1 SEARCH 14.1.1 Search by Time T
- Page 129 and 130: 14.2 PTZ control 1. Select the PTZ
- Page 131 and 132: 1) Press on the M button to change
- Page 133 and 134: III. Open the DVRViewer.exe for loa
- Page 135 and 136: 14.4 Remote Configuration Click on
- Page 137: CAMERA setup menu RECORD setup menu
- Page 141 and 142: WARNING setup menu SYSTEM setup men
- Page 143 and 144: 15.2 Remote Control Protocol A comp
- Page 145 and 146: 0x23 CH8 0x24 (reserve) 0x25 (reser
- Page 147 and 148: Appendix B: Alarm Board Configurati
- Page 149 and 150: Troubleshooting If you have difficu