FLEX Series Access Control Management Software - Everfocus

Finger_EN: reserved for fingerprint controller
Card_Expiration: whether the card has an expiration date. If Card_Expiration is
checked, the card has an expiration date. The expiration time can be set in
the Expiration time menu. The minimal time interval is 10 minutes.
Group: access control group setting. System assigns 01-64 access control groups for
all cardholders and applies different access control rules for different groups
(Refer to access control rules aforementioned in the manual). Note that a
cardholder can be assigned to different groups on different controllers.
Access PIN: the cardholder will be required to input the PIN if the PIN is enabled or
the door access setting requires a PIN. Click “Edit” button to edit the PIN.
Type in the PIN in “PIN” field and repeat it in “Confirm” field. Then click
“Confirm” button to confirm the change. (“Edit” button will show
“Confirm” after it was clicked.)
Access Right: whether a cardholder has the right to enter different zones of the
controller. Each zone corresponds to a button. If the button is pressed down,
the cardholder has the right to enter this zone. Otherwise not.
Once a card is applied to a controller, it will have the properties shown in Figure 8.19,
which are called the default card properties. Card_EN is enabled, Group is set to 01,
and all other properties are disabled. It has the access right to all zones of the controller.
Edit Access Attributes of a batch of cards
In some situation, a cardholder may have exact same access attributes in multiple
controllers, or multiple cardholders have the exact same access rights in one more
multiple controllers. EverAccess Flex software provides an efficient way to edit the
access attributes for a batch of cards. The procedure is as follows:
1. Filter the cardholder in the list. Only keep the cardholders whose access attributes
will be edited altogether.
2. Click the button to bring up the controller selection dialog box as in Figure
8.20.
72