FLEX Series Access Control Management Software - Everfocus

Enable Auto Daylight Saving Time
The box under to “Auto daylight saving time” allows the user to activate or deactivate
the automatic daylight saving time.
• Point and click the small circle to activate or deactivate the auto daylight saving
time.
Off: deactivate daylight saving time.
On: activate daylight saving.
Fig. 4.25 Set auto daylight saving
Set Arm Delay Time
When an ARM enabled card is swiped to pass a door, system will not generate an alarm
within the time delay period so that cardholder has time to disarm the system. This time
delay period is called arm delay time. EverAccess software allows the user to set the
Arm delay time.
The box next to “Arm delay time (Sec):” allows the user to change the Arm delay time.
1. Point and click the “Modify” button.
2. Type in the Arm delay time in seconds in the box provided.
3. Click the “Cancel” button to leave without changing the Arm delay time.
4. Click “OK” to confirm change of Arm delay time.
Fig. 4.26 Set arm delay time
Exit Controller Configurations
There are two ways to exit from the controller configuration window:
34