FLEX Series Access Control Management Software - Everfocus

Fig 4.9 Set the door location
4. Click the “OK” button to confirm the change.
Set Door Open Time
Door open time indicates how long the door relay will remain open once an access
request is granted. To change the door open time, follow the steps below:
1. Select a controller in the controller list.
2. Click the cell of the door open time to be modified.
3. Click the “Modify” button in the cell and change the door open time, as shown
in the following figure:
Fig 4.10 Change the door open time
4. Click the “OK” button to confirm the change.
Set Door Held Open Time
Door held open is the maximum amount of time (in seconds) a door can remain open
before an event or alarm is triggered. To change the Door held open time:
Fig. 4.11 Set the door held open time
1. Click and select a controller from the controller list.
2. Click the “Door held open” cell to be modified.
3. Click the “Modify” button that appears in the cell.
4. Change the door held open time.
21