FLEX Series Access Control Management Software - Everfocus

2. Click the “Modify” button at the top right corner of the controller setting area.
Please note that while in the modification mode, users cannot add or delete a
controller, or update a controllers’ status.
3. Click the COM port box to change the COM port for this controller. Refer to
the next figure:
Fig 4.7 Set the COM port of a controller
4. Click “OK” to confirm the change.
Configure Doors
In the door setting tab of the controller setting area, users can configure the door
settings of the specified controller, including door location description, door open time
and door held open time. A screenshot of door setting tab is shown in the following
figure.
Fig 4.8 Door setting tab for a controller
Edit Door Location Information
To edit the door location description, follow the steps below:
1. Select a controller in the controller list.
2. Click the cell of the location of the door that is being changed.
3. Click the “Modify” button in the cell and change the location description, as
shown in the following figure:
20