FLEX Series Access Control Management Software - Everfocus

Click “OK” to continue to delete this controller. Otherwise, click “Cancel” to keep the
controller.
Update the Status of Controllers
There are two methods of reconnecting to controllers on the network. To search for a
specific controller, click “Search” in the function bar. To search the network for
all controllers, click “Search all” to refresh the status of all the controllers listed in
the controller list.
After the button is clicked, the software will try to connect to controllers in the list and
refresh the controller status The connection and the settings of the specified controller
will be shown after the search is completed.
Configure a Controller
All the configurations for a controller can be managed in the controller setting area. The
details of how to configure a controller are introduced below.
Specify the Location of a Controller
Users can change the location description of a controller. To name a controller location,
follow the steps as below:
1. Select a controller in the controller list
2. Click the “Modify” button at the top right corner of the controller setting area.
Please note that while in the modification mode, users cannot add or delete a
controller, or update controllers’ status.
3. Change the location of the controller in the text box as shown in the following
figure:
4. Click “OK” to confirm the change.
Fig 4.6 Set the controller location
Change the Serial Port for a Controller
Similar to the process of editing the controller location description, click the “Modify”
button to change the COM port for a controller:
1. Select a controller from the controller list.
19