FLEX Series Access Control Management Software - Everfocus

Fig. 12.3 Arm/Disarm control
To remotely arm or disarm a particular controller:
1. Click the “+” to expand the controller list in the resource list to see all available
controllers.
2. Click the controller address to select the controller.
At this point, under the “Arm/Disarm” the controller address shows the
corresponding selected controller. For example, controller at address 0001 is
selected in the picture below.
Fig 12.4 Expand the controller list
3. Click “Armed” or “Disarm” buttons to arm or disarm the controller selected. The
arm/disarm status of the controller will be shown the same area.
For example, in the figure above, the controller 0001 is disarmed. Click the button
“Arm” will arm the controller 0001. And the button will be updated as “Disrm”;
the status will be updated as “Armed”, shown as the figure below:
106