Installation and Maintenance Instructions - ETO Doors
Installation and Maintenance Instructions - ETO Doors Installation and Maintenance Instructions - ETO Doors
e Q P W Always make sure you are using the proper hinge for the panel. Be careful about which screws you are using. (See: Where to use screws and nuts) Repeat the same steps for the remaining panels. P J I W(optional): install safety edge W at the right or left bottom corner as you required position.you can find the guide in our packing. f P S S S 2 arraies: 3601-4500mm 3 arraies: 4501-5800mm 4 arraies: 5801-7050mm S:assembling center hinge with screw no.1(one array center hing only if the door width within 3600mm). make sure the position is in the center of the door. X(optional): install the reinforcement(strut) X if the door width over 5500mm. L X 10
make the cable V go through between the door and the track J up to the cable drum O. Hook the end of the cable with a stop sleeve to the special notch on the drum O. O step six: Fasten the loop of the steel cable to its fastening point on the bottom panel corner bracket a, b, V turn the drum O manually until there is tension in the cable V, lock them with the specially designed pressure screws on the cable drum O. Repeat this step for the other cable. The two sides of the lift cables must be set equally taut. O V U K c, 11
- Page 1 and 2: INSTALLATION GUIDE-industiral door
- Page 3 and 4: Garage door installation: NO. DESCR
- Page 5 and 6: Packing components list: torsion sp
- Page 7 and 8: I J K step two: I&J: After checked
- Page 9: Keep hands and fingers clear of sec
- Page 13 and 14: final checkings: a,re-adjust torsio
- Page 15: Maintaineance A, The door - clean d
make the cable V go through<br />
between the door <strong>and</strong> the track<br />
J up to the cable drum O. Hook<br />
the end of the cable with a<br />
stop sleeve to the special<br />
notch on the drum O.<br />
O<br />
step six:<br />
Fasten the loop of the<br />
steel cable to its<br />
fastening point on the<br />
bottom panel corner<br />
bracket<br />
a,<br />
b,<br />
V<br />
turn the drum O manually until there<br />
is tension in the cable V, lock them<br />
with the specially designed pressure<br />
screws on the cable drum O.<br />
Repeat this step for the other<br />
cable.<br />
The two sides of the lift cables<br />
must be set equally taut.<br />
O<br />
V<br />
U<br />
K<br />
c,<br />
11
Change language