ETC Ion - Theatre Uwinnipeg

Hardware Setup
Rear Panel
Note:
Note:
Hard Power
Switch
AC Power
IEC connector
Dual DVI
Display
AC Input
100-240 VAC
50/60 Hz 2A
1
2
Electronic Theatre Controls, Inc.
Middleton, WI Made in USA
Net3 RVI
Mouse
Step 1: Attach the appropriate IEC power cord to the power connector, then to an AC
receptacle.
Step 2: Attach the dual DVI connector/Y-adapter to the DVI port.
If you have VGA monitors, attach the VGA adapters (provided) to the DVI Yadapter.
Do not use the VGA connectors on the back of the RVI.
The minimum screen resolution must be at least 1280x1024 with 32 bit color.
Step 3: Connect the USB mouse and keyboard to the USB connectors. If you wish to use a
PS2 mouse or keyboard (not provided), use the appropriate connectors on the RVI.
Step 4: Attach a network ethernet cable to the Ethernet port. All communications to the
associated control console are made over this Ethernet connection.
• Connection to the console may be made either directly using a Cat5 or better
null-modem cable or through an Ethernet hub or Ethernet switch using standard
Cat5 or better patch cables.
Step 5: When all connections are made, activate the hard power switch on the rear panel.
Step 6: Press the soft power switch, on the front of the unit, to power up the RVI.
If the unit does not power up, check the hard power switch on the rear panel, to
ensure it is switched on.
320 Ion Operations Manual
Dual DVI Display
Keyboard
Not Used
RS-232
Ethernet
Not Used
USB
x4
BTX - L OP IOSHLDR