ETC Ion - Theatre Uwinnipeg

Shutter Control
Pressing the [Shutter] button displays shutter controls, if there are any fixtures with framing
devices patched.
Press the [Shutter] button again to access the additional shutter controls, available to the specific
channel.
Color Control
Depending upon the specific device, color can be established manually with the encoders using:
• CMY color-mixing
• Hue and saturation color mixing
• RGB color-mixing
• Selection from a color wheel or scroller
You may also specify color by using the hue and saturation (HS) color picker and gel picker.
It is also possible to set non-intensity parameter data with direct entry using the control keypad and
using the parameters on the CIA.
• [1] [At] [4] {Cyan} [5] [5] [Enter]
Note:
Custom Control
Color scroller data will display on the encoders and displays as frame numbers,
F1, which would be frame 1, F2 for frame 2, etc. F1.5 is halfway between 1 and 2.
F2+ will display if the frame is less than 2.5 and F2- if the frame is greater than 1.5.
After the frame number, the gel number will also be displayed.
Frame numbers can be used from the command line. [2]{Scroller}[5][Enter] will
send channel 2’s scroller to frame 5. Frames can also be selected by using the
DMX address for that frame. Pressing [/] twice will post DMX to the command line.
[3] {Scroller} [/][/][2][5][5] [Enter] will send channel 3’s scroller to the frame with
the DMX address of 255.
Pressing the [Custom] button displays intensity controls.
8 Basic Manual Control 117