ETC Ion - Theatre Uwinnipeg

{ACN - MIDI Tx ID}
This setting allows you to specify the ID number of MIDI Show Control data that Ion transmits over
an Advanced Control Network (ACN). When set, Ion will transmit MSC data to any gateway that has
its “MIDI Out Stream ID” set to the same number. ACN_MIDI Transmit ID can be from 1-32. ID
ranges may be used.
• {ACN_MIDI Transmit ID} [2] [5] [Enter]
{Analog Inputs}
This touchbutton toggles the setting for receiving analog inputs between “Enabled” and “Disabled”.
Default is “Enabled”.
{Relay Outputs}
This touchbutton toggles the setting for allowing Ion to trigger external relays. Options are
“Enabled” or “Disabled”. The default is “Enabled”.
{Serial Enable}
This touchbutton toggles the ability to receive serial commands. Options are “Enabled” or
“Disabled”. The default is “Enabled”.
{Serial Group Ids}
This touchbutton is for setting up which serial group IDs the Ion will listen to. Serial Group IDs are
from 1-32. Ion can be set to listen to multiple group IDs.
• {Serial Group Ids} [1] [+] [5] [Enter]
Partitions
Pressing the {Partitions} button in Show setup opens the partition display in the CIA. This display
shows any recorded partitions, including the four pre-existing partitions. For more information, see
Using Partitioned Control, page 289.
Note: Filter setup and encoder configuration settings are not available at this time.
7 Setup 99