ETC Ion - Theatre Uwinnipeg

Show Settings
Click {Show Settings} to enter this category.
Five fields will be available to you: {Num of Channels}, {Auto-Mark}, {Dim. Dbl. Offset},
{Partitioned Control}, and {Home Preset}. To change the setting for any of these fields, click the
field in the CIA to activate it. If the field requires data, enter it from the keypad. If the field is a toggle
state, one click of the button will switch the field to its other state.
Changes from this screen are systemwide and will impact all Ion consoles and clients connected to
the system.
{Num of Channels}
You may use this field to set the number of channels in your Ion to the number of channels in your
system. Ion supports a maximum of 10,000 channels. Enter the number of channels for your
system using the keypad. This entry must be confirmed with the [Enter] key.
{Auto-Mark}
This toggles the AutoMark settings between enabled and disabled (see Using Mark, page 175 for
more information). AutoMark is disabled by default.
{Dimmer Double Offset}
This allows you to set the address offset for dimmer doubling. The default for this is 20000, to match
the Net2 standard offset, including Sensor+ software.
{Partitioned Control}
Enables or disables the assigning of partitions. Default is “Disabled” (see Using Partitioned Control,
page 289 for more information).
{Home Preset}
Allows you to specify a preset that will be used as the home level for all non-intensity parameters
stored in the preset, instead of the fixture library defaults. This preset will be applied for all “Go to
Cue Out” and home commands. Intensity values in the preset will be ignored. Channels not
included in the assigned home preset will continue to home to their library defaults.
Cue Settings
This screen allows you to set the default cue times for the parameter categories of your Ion system.
To change a time, click the parameter category button in the CIA and enter the desired time on the
keypad. To set a time for all categories at once, press [Intensity Up] [Thru]. Pressing [At] selects
manual times.
The categories for which you may set default times are:
• Intensity Up
• Intensity Down
• Focus
• Color
• Beam
7 Setup 95