LTC Repair Lombardini Engine Troubleshooting - Wacker Neuson

Maintenance LTC Repair
4.3 Installing / Removing Light Fixtures
b
See Graphic: wc_gr003907
WARNING
WARNING
ALWAYS turn off the light circuit breakers and shut down the engine
before disconnecting the light fixtures or changing the light bulbs.
The bulbs become extremely hot in use! Allow the bulb and the
fixture to cool 10–15 minutes before handling them.
4.3.1 Remove the fixtures by disconnecting the electrical wiring at the
junction box (a). NOTICE: Only a trained technician should be allowed
to install and remove the fixture wiring.
4.3.2 Remove the nuts (b) from the fixture mounting brackets and remove
both the fixture and the bracket off the stud.
4.3.3 Adjusting clamps (c) may be moved from side to side as desired by
unscrewing them and swapping positions with the locknut on the
oppositie side of the fixture.
a
c
50Hz 60Hz
40
b
a
c
wc_gr003907