LTC Repair Lombardini Engine Troubleshooting - Wacker Neuson

Disassembly/Assembly Procedures LTC Repair
7.12 Replacing Fuel Tank
See Graphic: wc_gr003534
Removal:
7.12.1 Turn off the lights, shut down the engine, and disconnect the battery.
7.12.2 Position the main mast in the vertical position.
Note: It is not necessary to raise the tower.
7.12.3 Remove the screws securing the mast cradle (a) and remove the mast
cradle.
7.12.4 Remove the ground wires (b) between the doors and the top.
7.12.5 Remove the doors (c).
7.12.6 Remove the screws (f) that secure the top and remove the top.
7.12.7 Drain any remaining fuel in the fuel tank.
7.12.8 Snip the wire ties (g).
7.12.9 Remove the bolts (h) securing the hold-down straps (i).
7.12.10 Disconnect the fuel intake (j) and return lines (k).
7.12.11 With the aid of a partner or appropriate hoist, lift the fuel tank from the
machine.
Installation:
7.12.12 Position the fuel tank into the machine.
7.12.13 Slide the new wire ties (g) underneath the hold-down straps (i) and
secure the fuel tank to the machine with the hold-down straps using the
bolts (h).
7.12.14 Reconnect the fuel intake (j) and return lines (k).
7.12.15 Reinstall the top with the screws (f).
7.12.16 Reinstall the doors.
7.12.17 Reinstall the ground wires (b) between the doors and the top.
7.12.18 Reinstall the cradle (a).
138