LTC Repair Lombardini Engine Troubleshooting - Wacker Neuson
LTC Repair Lombardini Engine Troubleshooting - Wacker Neuson
LTC Repair Lombardini Engine Troubleshooting - Wacker Neuson
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Disassembly/Assembly Procedures <strong>LTC</strong> <strong>Repair</strong><br />
7.11 Replacing Cable and Winch on Power Winch Models<br />
See Graphic: wc_gr003159<br />
Removal:<br />
7.11.1 Lower the tower.<br />
7.11.2 Lower the mast assembly into the cradle.<br />
7.11.3 Turn off the engine.<br />
7.11.4 Remove the four screws (a) which secure the cover of the winch and<br />
remove the cover.<br />
Pinching hazard. Use extreme care when operating the winch with its<br />
cover removed.<br />
CAUTION<br />
7.11.5 Using the appropriate switch (b) or the auxiliary handle (c), run the<br />
winch so that all remaining cable is unwound from the spool. Do not<br />
run the winch for periods of longer than four minutes. Allow the winch<br />
to cool if necessary.<br />
7.11.6 Position the spool so that the retaining clamp (d) is accessible.<br />
7.11.7 Loosen the screw which secures the clamp and the cable, and remove<br />
the cable from the spool.<br />
7.11.8 To remove the winch, disconnect the motor wires (f). Then, remove the<br />
screws (g) which secure the winch to the machine and remove the<br />
winch.<br />
Installation:<br />
7.11.9 To install the winch, position the winch on the machine and secure it<br />
with the screws (g). Then, connect the motor wires (f).<br />
7.11.10 Thread the cable through the hole in the spool (e) so that when the<br />
winch reels in the cable, the cable winds around the top of the spool.<br />
7.11.11 Secure the cable to the spool using the cable clamp (d) and screw. Be<br />
sure to secure the cable in both sides of the clamp.<br />
7.11.12 Use the appropriate switch (b) or auxiliary handle (c) to wind up the<br />
cable.<br />
7.11.13 Reinstall the cover using the four screws (a).<br />
136