211i Operating Manual FabricatOr® - Victor Technologies - Europe
211i Operating Manual FabricatOr® - Victor Technologies - Europe
211i Operating Manual FabricatOr® - Victor Technologies - Europe
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
INSTALLATION/SETUP FABRICATOR <strong>211i</strong><br />
3.08 Installing 15kg Spool (300mm diameter)<br />
As delivered from the factory, the unit is fitted with a Wire Spool Hub which accepts a Spool of 300mm diameter.<br />
Remove the locking pin from the spool hub. Install the wire spool over the spool hub, locating the hole in the<br />
spool, with the alignment pin on the spool hub.Insert the locking pin back into the spool hub.<br />
Wire Spool<br />
Hub Nut<br />
300mm<br />
Wire Spool<br />
Flat Washer<br />
Large Hole<br />
Flat Washer<br />
Small Hole<br />
Spring<br />
Retaining Clip<br />
Use inner holes on<br />
Spool Hub<br />
Keyed Washer<br />
Pin<br />
Spool Hub<br />
Fibre Washer<br />
Figure 3-6: 300mm 15kg Spool Installation<br />
3.09 Installing 5kg Spool (200mm diameter)<br />
Remove the locking pin from the spool hub.<br />
Art # A-10939<br />
Install the 5kg Spool over the spool hub, locating the hole in the 5kg Spool, with the alignment pin on the Spool Hub.<br />
Insert the locking pin back into the spool hub, in the “rear” position, as shown, ensuring the wire spool is firmly<br />
secured in position.<br />
Wire Spool<br />
Hub Nut<br />
200mm<br />
Wire Spool<br />
Flat Washer<br />
Large Hole<br />
Flat Washer<br />
Small Hole<br />
Spring<br />
Retaining Clip<br />
Use inner holes on<br />
Spool Hub<br />
Keyed Washer<br />
Pin<br />
Spool Hub<br />
Fibre Washer<br />
Figure 3-7: 200mm 5kg Spool Installation<br />
Art # A-10940<br />
<strong>Manual</strong> 0-5225 3-11 INSTALLATION/SETUP