211i Operating Manual FabricatOr® - Victor Technologies - Europe

FABRICATOR 211i INSTALLATION/SETUP
19. Burnback Control (located in wirefeed compartment)
The burnback control is used to adjust the amount of MIG wire that protrudes from the MIG gun after the
completion of MIG welding (commonly referred to as stick out). To decrease the burnback time (or lengthen
the amount of wire protruding from the MIG gun at the completing of welding), turn the burnback control
knob anti clockwise. To increase the burnback time (or shorten the amount of wire protruding from the MIG
gun at the completing of welding), turn the Burnback Control knob clockwise.
20. MIG Gun/ SPOOL Gun Switch (located in wirefeed compartment)
The MIG Gun / SPOOL Gun switch is used to switch welding mode between MIG Gun functionality and SPOOL
Gun functionality.
21. Cooling Fan
The Fabricator 211i is fitted with a fan as needed feature. Fan as needed automatically switches the cooling
fan off when it is not required. This has two main advantages; (1) to minimize power consumption, and (2) to
minimise the amount of contaminants such as dust that are drawn into the power source.
Note that the fan will only operate when required for cooling purposes and will automatically switch off when
not required.
3.07 Attaching MIG Gun
Fit the MIG gun to the power source by pushing the MIG gun connector into the MIG gun adaptor and screwing
the plastic nut clockwise to secure the MIG gun to the MIG gun adaptor.
MIG Gun Adaptor
MIG Gun Connector
Art # A-10423_AB
Figure 3-5: Attaching MIG Gun
INSTALLATION/SETUP 3-10 Manual 0-5225