211i Operating Manual FabricatOr® - Victor Technologies - Europe
211i Operating Manual FabricatOr® - Victor Technologies - Europe
211i Operating Manual FabricatOr® - Victor Technologies - Europe
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
FABRICATOR <strong>211i</strong> INTRODUCTION<br />
2.05 User Responsibility<br />
This equipment will perform as per the information contained<br />
herein when installed, operated, maintained and<br />
repaired in accordance with the instructions provided.<br />
This equipment must be checked periodically. Defective<br />
equipment (including welding leads) should not be used.<br />
Parts that are broken, missing, plainly worn, distorted or<br />
contaminated, should be replaced immediately. Should<br />
such repairs or replacements become necessary, it is<br />
recommended that such repairs be carried out by appropriately<br />
qualified persons approved by Thermal Arc.<br />
Advice in this regard can be obtained by contacting an<br />
Accredited Thermal Arc Distributor.<br />
This equipment or any of its parts should not be altered<br />
from standard specification without prior written approval<br />
of Thermal Arc. The user of this equipment shall<br />
have the sole responsibility for any malfunction which<br />
results from improper use or unauthorized modification<br />
from standard specification, faulty maintenance,<br />
damage or improper repair by anyone other than appropriately<br />
qualified persons approved by Thermal Arc.<br />
2.06 Transportation Methods<br />
This unit is equipped with a handle for carrying purposes.<br />
!<br />
WARNING<br />
ELECTRIC SHOCK can kill. DO NOT TOUCH<br />
live electrical parts. Disconnect input power<br />
conductors from de-energized supply line<br />
before moving the welding power source.<br />
!<br />
WARNING<br />
FALLING EQUIPMENT can cause serious<br />
personal injury and equipment damage.<br />
Lift unit with handles built into the top of the front and<br />
rear moulded panels.<br />
Use handcart or similar device of adequate capacity.<br />
If using a fork lift vehicle, place and secure unit on a<br />
proper skid before transporting.<br />
2.07 Packaged Items<br />
Fabricator <strong>211i</strong> Power Source (Part No. W1004206)<br />
• Fabricator <strong>211i</strong> Inverter Power Source<br />
• Shielding Gas hose assembly<br />
• <strong>Operating</strong> <strong>Manual</strong><br />
Fabricator <strong>211i</strong> System Part No. (W1004207)<br />
• Fabricator <strong>211i</strong> Inverter Power Source<br />
• Feedrolls 0.6/0.8mm "V" groove (fitted),<br />
0.9/1.2mm "V" groove,<br />
1.0/1.2mm "U" groove,<br />
0.8/0.9mm "V" knurled,<br />
• MIG gun 3m long<br />
• Electrode Holder with 4m lead<br />
• Work Clamp with 4m lead<br />
• Shielding Gas hose assembly<br />
• <strong>Operating</strong> <strong>Manual</strong><br />
Figure 2-1: Fabricator <strong>211i</strong> System Packaged W1004207<br />
INTRODUCTION 2-2 <strong>Manual</strong> 0-5225