DocLib_42_0-4905 ArcMaster 400MST CE.pdf - Victor Technologies ...
DocLib_42_0-4905 ArcMaster 400MST CE.pdf - Victor Technologies ...
DocLib_42_0-4905 ArcMaster 400MST CE.pdf - Victor Technologies ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Description Possible Cause Remedy<br />
8 Electrode melts or<br />
oxidizes when an arc<br />
is struck.<br />
A No gas flowing to<br />
welding region.<br />
44<br />
A Check the gas lines for kinks<br />
or breaks and gas cylinder<br />
contents.<br />
B Torch is clogged with dust. B Clean torch.<br />
C Gas hose is cut. C Replace gas hose.<br />
D Gas passage contains D Disconnect gas hose from<br />
impurities.<br />
torch then raise gas pressure<br />
and blow out impurities.<br />
E Gas regulator turned OFF. E Turn ON.<br />
F Torch valve is turned OFF. F Turn ON.<br />
G The electrode is too small for G Increase electrode diameter or<br />
the welding current.<br />
reduce the welding current.<br />
H WAVE BALAN<strong>CE</strong> is set above H Reduced WAVE BALAN<strong>CE</strong> to<br />
50%.<br />
below 50% or increase the<br />
electrode size.<br />
9 Poor weld finish. Inadequate shielding gas. Increase gas flow or check<br />
gas line for gas flow<br />
problems.<br />
10 Arc flutters during A Tungsten electrode is too A Select the right size electrode.<br />
TIG welding.<br />
large for the welding current. Refer to Basic TIG Welding<br />
guide.<br />
B Absence of oxides in the B Refer Basic TIG Welding<br />
weld pool.<br />
Guide for ways to reduce arc<br />
flutter.<br />
11 Welding arc cannot A Work clamp is not connected A Connect the work clamp to the<br />
be established. to the work piece or the work piece or connect the<br />
work/torch leads are not work/torch leads to the right<br />
connected to the right welding<br />
terminals.<br />
welding terminals.<br />
B Torch lead is disconnected. B Connect it to the ‘−‘ terminal.<br />
C Gas flow incorrectly set, C Select the right flow rate,<br />
cylinder empty or the torch change cylinders or turn torch<br />
valve is OFF.<br />
valve ON.