CutMaster True Service Manual - Victor Technologies - Europe
CutMaster True Service Manual - Victor Technologies - Europe
CutMaster True Service Manual - Victor Technologies - Europe
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
SECTION 3 TORCH:<br />
INSTALLATION<br />
3T.01 Torch Connections<br />
If necessary, connect the torch to the Power Supply.<br />
Connect only the Thermal Dynamics model<br />
SL60 / <strong>Manual</strong> or SL100 / Mechanical Torch to<br />
this power supply. Maximum torch leads length<br />
is 100 feet / 30.5 m, including extensions.<br />
WARNING<br />
Disconnect primary power at the source<br />
before connecting the torch.<br />
1. Align the ATC male connector (on the<br />
torch lead) with the female receptacle.<br />
Push the male connector into the female<br />
receptacle. The connectors should push<br />
together with a small amount of pressure.<br />
2. Secure the connection by turning the locking<br />
nut clockwise until it clicks. DO NOT<br />
use the locking nut to pull the connection<br />
together. Do not use tools to secure the<br />
connection.<br />
Art # A-07885<br />
Connecting the Torch to the Power Supply<br />
3. The system is ready for operation.<br />
1<br />
2<br />
Check Air Quality<br />
To test the quality of air:<br />
CUTMASTER 25mm<br />
1. Put the ON / OFF switch in the ON<br />
(up) position.<br />
2. Put the Function Control switch in the SET<br />
position.<br />
3. Place a welding filter lens in front of the<br />
torch and turn on the air. Do not start an<br />
arc!<br />
Any oil or moisture in the air will be visible<br />
on the lens.<br />
3T.02 Setting Up Mechanical Torch<br />
NOTE<br />
An adapter is required to be installed in the power<br />
supply if converting a hand torch system to operate<br />
a machine torch.<br />
WARNING<br />
Disconnect primary power at the source before<br />
disassembling the torch or torch leads.<br />
The mechanical torch includes a positioning tube<br />
with rack and pinch block assembly.<br />
1. Mount the torch assembly on the cutting<br />
table.<br />
2. To obtain a clean vertical cut, use a square<br />
to align the torch perpendicular to the surface<br />
of the workpiece.<br />
<strong>Manual</strong> 0-5081 3T-1 INSTALLATION