CutMaster True Service Manual - Victor Technologies - Europe

CUTMASTER 25MM
Type of Power
Supply (Note 1)
Plasma Cutting
Symbol
Input Power
Symbol
Input Power
Specifications
(Phase, AC or DC
Hertz Rating)
APPENDIX 2: DATA TAG INFORMATION
Model:
Date of Mfr:
1/3 f
1
f
2
Rated No-
Load Voltage
Output Current Type
U0 =
Degree of Protection
X
U2
West Lebanon, NH USA 03784
S/N
I I
Made in USA
1max 1eff
U1 1Ø 1 3Ø 1Ø 1 3Ø
NOTES:
1. Symbol shown indicates single- or three-phase AC input,
static frequency converter-transformer-rectifier, DC output.
2. Indicates input voltages for this power supply. Most power
supplies carry a label at the input power cord showing input
voltage requirements for the power supply as built.
3. Top row: Duty cycle values.
IEC duty cycle value is calculated as specified by
the International ElectroTechnical Commission.
TDC duty cycle value is determined under the power supply
manufacturer's test procedures.
Second row: Rated cutting current values.
Third row: Conventional load voltage values.
4. Sections of the Data Tag may be applied to separate areas
of the power supply.
I
Conventional
Load Voltage
Rated Supply
Voltage (Note 2)
Duty Cycle Factor
Rated Maximum
Supply Current
Standard Symbols
APPENDIX A-2 Manual 0-5081
Ø
AC
DC
Manufacturer's Name and/or
Logo, Location, Model and
Revision Level, Serial Number
and Production Code
Regulatory Standard Covering
This Type of Power Supply
Output Range (Amperage/
Voltage)
Duty Cycle Data (Note 3)
Maximum Effective
Supply Current
Manufacturer's Electrical
Schematic File Number
and Revision Level
Phase
Art # A-03288