iTNC 530 - TNC 640 - DR. JOHANNES HEIDENHAIN GmbH
iTNC 530 - TNC 640 - DR. JOHANNES HEIDENHAIN GmbH
iTNC 530 - TNC 640 - DR. JOHANNES HEIDENHAIN GmbH
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
2012: <strong>TNC</strong> <strong>640</strong> for<br />
milling/turning<br />
machines<br />
Inside contour—<br />
1983: <strong>TNC</strong> 150<br />
“Old” programs also run on newer <strong>TNC</strong><br />
controls<br />
Part programs from your NC program<br />
archive that were written on older <strong>TNC</strong><br />
contouring controls can also be run on an<br />
<strong>i<strong>TNC</strong></strong> <strong>530</strong> with very little effort. This<br />
ensures the greatest possible fl exibility in<br />
machine utilization and provides enormous<br />
cost benefi ts if you fi nd you have to<br />
produce old parts again. <strong>HEIDENHAIN</strong><br />
contouring controls put you in the position<br />
to manufacture a replacement part quickly<br />
and economically even now—after more<br />
than 30 years—without having to<br />
reprogram it.<br />
programmed with the <strong>TNC</strong> 145...<br />
1981: <strong>TNC</strong> 145,<br />
the fi rst contouring control<br />
from <strong>HEIDENHAIN</strong><br />
...machined with the <strong>i<strong>TNC</strong></strong> <strong>530</strong><br />
Familiar function keys take on new<br />
tasks<br />
Of course, many innovations and<br />
improvements have been included<br />
in the <strong>i<strong>TNC</strong></strong> <strong>530</strong>—but the fundamental<br />
programming procedure has remained the<br />
same. When you switch to a new control<br />
you do not need to relearn the programming<br />
and operation. You only need to become<br />
familiar with the new functions. So you can<br />
apply your professional knowledge as a<br />
machinist immediately even on a new <strong>TNC</strong><br />
control.<br />
9