34049x-02 - DR. JOHANNES HEIDENHAIN GmbH

More documents

Recommendations

Info

New Programming Functions – Conversational Programming Point fi lter for smoothing NC programs created offl ine With this TNC function you can make contours smoother that were created on external programming systems. The fi lter function creates a copy of the original program, and then adds any points required by the parameters that you set. This smoothes the contour to allow the program to run more quickly and with less jerk. Conversational: new 3-D line graphics with powerful zoom function 3-D line graphics, for 3-D display of tool center-point path (upgrade function) The new line graphics display the programmed contour in three dimensions. With the powerful zoom function you can also see the details. You should especially use the 3-D line graphics to inspect programs created offl ine for irregularities before machining, in order to avoid undesirable traces of the machining process on the workpiece. In order to fi nd the error location quickly, the currently active block of the 3-D line graphics appears highlighted in the left window. In addition, the respective programmed end points can be displayed to show any concentrations of points. 8 Manual traverse in the active tool-axis system (upgrade function) Use this function in the Manual and Electronic Handwheel operating modes, as well as during a program interruption in the Program Run, Full Sequence operating mode to move the tool with the external direction keys or the handwheel in the direction in which the tool axis is currently pointed. This function is especially useful in fi ve-axis programs if you need to retract the tool and do not have detailed information about the tool-axis direction. Conversational: simple editing of a preset table More Convenient Preset Table Now, you access a preset table directly with the PRESET TABLE soft key in the Manual operating mode. There are also new possibilities for saving values in the preset table: Use the actual position of the tool or dial gauge as the new preset Assign any value to the actual position of the tool or dial gauge Incrementally shift a preset already saved in the table Directly enter the new preset without calculation of the kinematics
– Programming Station Since the beginning of this year, the iTNC programming station has been shipped with a new keyboard. The new keyboard has a much leaner housing and includes the new smarT.NC keys. The following improvements are available in the programming station version 340494-<strong>02</strong>. • • • All software options and FCL functions fully enabled One special benefi t: the complete array of soft ware options and FCL functions available for the control are fully enabled here. This enables users of the licensed or free demo versions (down load at www.heidenhain.de/service) to amply test all functions and then decide whether an upgrade on the machine is worthwhile. Virtual keyboard Especially the users of the demo version of the programming station can get an even better idea of how easy it is to operate the TNC using the keyboard. Use the iTNC control panel to open a virtual TNC keyboard on the screen, providing the control‘s most important dialog initiation keys. You will need a screen resolution of at least 1280x1<strong>02</strong>4 to be able to see the control screen and the virtual key board at the same time. PLC basic program optionally installable When installing the programming station software, you can now also install the PLC basic program. This lets you perform a “dry run” in the Program Run modes with the programs created on the programming station, and the position display runs as well. 9
Page 1 and 2: iTNC 530 New Functions with NC Soft
Page 3 and 4: Important for the Protection of the
Page 5 and 6: - General New Features A number of
Page 7: Tooltips displayed when using the m
Page 11 and 12: Mode of operation Conversational pr

34049x-02 - DR. JOHANNES HEIDENHAIN GmbH

Create successful ePaper yourself

Delete template?

Save as template?