34049x-02 - DR. JOHANNES HEIDENHAIN GmbH

More documents

Recommendations

Info

New Programming Functions – smarT.NC Mid-program startup with graphic support (upgrade function) The pattern generator in smarT.NC is a powerful feature for defi ning machining positions fl exibly and with graphic support. The positions are saved blockwise in point tables for convenient reuse at other locations for other operations. Now the reentry into a machining program has been adapted to this fl exible function: smarT.NC detects your entry into a unit in which machining positions are defi ned, and symbolically displays the positions in a preview window. You can now select via soft key at which position you would like to begin machining. smarT.NC then automatically inserts the appropriate tool and traverses to the selected position—of course only after your approval. CUT/COPY/PASTE of one or more units Using the key combinations you are familiar with from Windows, you can copy an entire unit or insert it at any other location in the program. Naturally, the SELECT BLOCK function you know from conversational programming is also available for the copying and pasting of multiple units. Feed rate also possible as FZ/FU/FMAX When specifying the feed rate, you can also enter a revolution feed rate in mm/rev or a cutting feed rate mm/tooth instead of in mm/min. 6 smarT.NC: mid-program startup
Tooltips displayed when using the mouse If you hold the mouse over an entry fi eld or selection box for more than one second, the iTNC displays a tooltip. Tooltips contain information or important notes about the respective function. Tool data editable during tool selection In the pop-up window for tool selection you can now also change the tool data shown there. The TNC automatically saves these changes in the tool table TOOL.T. Axis keys now position the cursor in forms as well Up to now, experienced conversational dialog programmers have been wanting to use the orange axis keys in smarT.NC for contour programming. Now they can. The orange I key (incremental/absolute switchover) and P key (polar/rectangular switchover) can now also be used. Automatic entry of workpiece blank into contour program When you create a new contour program, smarT.NC automatically takes the workpiece blank defi ned in the unit program. This transfer can be updated by soft key at any time. Incremental entry of machining positions When defi ning the positions directly in the form for each machining unit, the positions can now also be entered incrementally. smarT.NC: Tooltips when using the mouse smarT.NC: Editing the tool data during tool selection 7
Page 1 and 2: iTNC 530 New Functions with NC Soft
Page 3 and 4: Important for the Protection of the
Page 5: - General New Features A number of
Page 9 and 10: - Programming Station Since the beg
Page 11 and 12: Mode of operation Conversational pr

34049x-02 - DR. JOHANNES HEIDENHAIN GmbH

Create successful ePaper yourself

Delete template?

Save as template?