2006 Mandalay Motorhome Owners Manual - Thor Motor Coach
2006 Mandalay Motorhome Owners Manual - Thor Motor Coach
2006 Mandalay Motorhome Owners Manual - Thor Motor Coach
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
IDENTIFICATION & SAFETY<br />
SEAT BELTS<br />
Do not occupy beds or any other seats that are not equipped with safety seat belts while<br />
the motorhome is in motion. Do not use a seat belt on more than one person.<br />
Pilot & co-pilot seats must be locked in a forward facing position with seat belts fastened<br />
while the motorhome is in motion. Avoid seat rotation while in transit.<br />
The sleeping accommodations in this vehicle are designed for occupancy only while the<br />
vehicle is parked. All occupants in this vehicle must be seated at a designated seating<br />
position and must wear seat belts at all times while this vehicle is in motion.<br />
Safety belts and seats can become hot in a vehicle that has been closed up in sunny<br />
weather; they could burn a small child. Check seat covers and buckles before you place<br />
a child anywhere near them.<br />
Seat Belt Operation<br />
All occupants must be furnished with and use seat belts while the motorhome is moving.<br />
However, it is not intended for all seats to be simultaneously occupied while the vehicle is in<br />
motion without regard to the total loaded weight of the vehicle.<br />
Maintenance<br />
Insert the belt tongue into the proper buckle (the buckle closest to the<br />
direction the tongue is coming from) until you hear a snap and feel it latch.<br />
Make sure the tongue is securely fastened in the buckle.<br />
Adjust the belt to the proper position; snug and as low as possible around the<br />
hips, not around the waist.<br />
To unfasten, push the release button and remove the tongue from the buckle.<br />
Failure to inspect and if necessary replace the safety belt under the above conditions<br />
could result in severe personal injuries in the event of a collision.<br />
Inspect the safety belts periodically to make sure they work properly and are not damaged.<br />
Inspect the safety belts to make sure there are no nicks, tear or cuts. Replace if necessary.<br />
A qualified service technician should inspect all safety belt assemblies after a collision.<br />
Four Winds International/<strong>Mandalay</strong> Luxury Division recommends that all safety belt<br />
assemblies used in vehicles involved in a collision be replaced.<br />
3-14<br />
MANDALAY