DC motor - Siemens, s.r.o.
DC motor - Siemens, s.r.o.
DC motor - Siemens, s.r.o.
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Maintenance<br />
Warning<br />
Especially when carrying out cleaning work with compressed air, ensure that<br />
suitable extraction measures are used and you use personal protective gear<br />
(goggles, face mask/filter or similar).<br />
Removing the carbon dust<br />
see also<br />
Deposits of carbon dust on insulating parts must be removed in their entirety, for<br />
example with a brush and suitable extraction device. Motors with a closed internal<br />
circuit without a fine dust filter must be dismantled after about three brush sets<br />
have been worn down and the carbon dust must be thoroughly cleaned from<br />
everything.<br />
Note<br />
When cleaning the brush rockers, take care if a brush-height monitoring device is<br />
fitted that its actuating mechanism is not damaged.<br />
Notice<br />
On fan units with sound absorbers, the surface of the sound absorber elements is<br />
pressure-sensitive. Do not, therefore, clean this directly with compressed air.<br />
Proceed only as follows: carefully brush off large collections of dust that can be<br />
sucked up as a whole by the air flow. If filter mats are fouled, either replace them<br />
or remove them, wash them out in the normal way, dry them and reinstall them<br />
unwetted.<br />
After completing cleaning, check the insulation resistance.<br />
[ID 571]<br />
Checking the insulation resistance [→ Page 4-3]<br />
6.1.5 Maintenance of the carbon brushes<br />
General<br />
When carbon brushes are replaced it must be ensured that the design of the new<br />
carbon brushes matches that of the worn brushes.<br />
The brush type and manufacturer's mark are shown on the upper part of the brush<br />
on carbon brushes.<br />
Warning<br />
When working with brush holders there is a risk of personal injury or material<br />
damage when open pressure levers spring back.<br />
[ID 573]<br />
SIEMENS AG T61160347010001 (DMHO V9)<br />
6-4 Operating instructions 1GG6286-0NA4.-1VV1-Z