1.0 Introduction:
1.0 Introduction: 1.0 Introduction:
wire header cable (on the solder side of the board) off to your target system. This can be any 87x target board. You just pop the 40 pin header into your board. Depending on VCC requirements, you may choose to use JP4 to isolate or extend the power to the target board. 28 pin Skinny Dip: OK, there is no way you are going to get this matching up via a 40 pin header system, but it's not that hard to do. 1) Crimp a special cable. 2) Use a small proto board to give you a 40 pin input to a 28 pin output with male header pins, and 28 wires. and use crimp connectors in and out. 15
- Page 1 and 2: VIKON Technologies 6 Way Road Middl
- Page 3 and 4: Table of Contents 1.0 Introduction:
- Page 5 and 6: • PIC16F87X / PIC16LF87X versions
- Page 7 and 8: 3.1.3 I 2 C EEPROM Option 1. U4 - E
- Page 9 and 10: This header mates with J1, the 10 p
- Page 11 and 12: protection diodes on the PIC. How e
- Page 13 and 14: 9.0 Compatability with In Circuit D
- Page 15 and 16: 'PIC Basic (for non Pro version) LC
- Page 17: 11.0 Additional Information: 11.1 I
wire header cable (on the solder side of the board) off to your target system. This can be any 87x<br />
target board. You just pop the 40 pin header into your board. Depending on VCC requirements,<br />
you may choose to use JP4 to isolate or extend the power to the target board.<br />
28 pin Skinny Dip:<br />
OK, there is no way you are going to get this matching up via a 40 pin header system, but it's not<br />
that hard to do.<br />
1) Crimp a special cable.<br />
2) Use a small proto board to give you a 40 pin input to a 28 pin output with male header pins,<br />
and 28 wires. and use crimp connectors in and out.<br />
15