vSphere Storage - ESXi 5.1 - Documentation - VMware
vSphere Storage - ESXi 5.1 - Documentation - VMware
vSphere Storage - ESXi 5.1 - Documentation - VMware
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>vSphere</strong> <strong>Storage</strong><br />
4 Configure one-way CHAP in the CHAP area.<br />
a Deselect Inherit from parent.<br />
b Select one of the following options:<br />
n Do not use CHAP unless required by target<br />
n Use CHAP unless prohibited by target<br />
n Use CHAP. To be able to configure mutual CHAP, you must select this option.<br />
c Specify the CHAP name.<br />
Make sure that the name you specify matches the name configured on the storage side.<br />
n To set the CHAP name to the iSCSI initiator name, select Use initiator name.<br />
n To set the CHAP name to anything other than the iSCSI initiator name, deselect Use initiator<br />
name and enter a name in the Name field.<br />
d Enter a one-way CHAP secret to be used as part of authentication. Make sure to use the same secret<br />
that you enter on the storage side.<br />
5 To configure mutual CHAP, first configure one-way CHAP by following directions in Step 4.<br />
Make sure to select Use CHAP as an option for one-way CHAP. Then, specify the following in the Mutual<br />
CHAP area:<br />
a Deselect Inherit from parent.<br />
b Select Use CHAP.<br />
c Specify the mutual CHAP name.<br />
d Enter the mutual CHAP secret. Make sure to use different secrets for the one-way CHAP and mutual<br />
CHAP.<br />
6 Click OK.<br />
7 Rescan the initiator.<br />
If you change the CHAP or mutual CHAP parameters, they are used for new iSCSI sessions. For existing<br />
sessions, new settings are not used until you log out and login again.<br />
Set Up CHAP for Target in the <strong>vSphere</strong> Web Client<br />
If you use software and dependent hardware iSCSI adapters, you can configure different CHAP credentials<br />
for each discovery address or static target.<br />
The CHAP name should not exceed 511 and the CHAP secret 255 alphanumeric characters.<br />
Prerequisites<br />
n Before setting up CHAP parameters for software or dependent hardware iSCSI, determine whether to<br />
configure unidirectional or bidirectional CHAP.<br />
n Verify CHAP parameters configured on the storage side. Parameters that you configure must match the<br />
ones one the storage side.<br />
n Access storage adapters.<br />
n Required privilege: Host.Configuration.<strong>Storage</strong> Partition Configuration<br />
Procedure<br />
1 Select the iSCSI adapter to configure, and click the Targets tab under Adapter Details.<br />
2 Click either Dynamic Discovery or Static Discovery.<br />
106 <strong>VMware</strong>, Inc.