vSphere Storage - ESXi 5.1 - Documentation - VMware
vSphere Storage - ESXi 5.1 - Documentation - VMware
vSphere Storage - ESXi 5.1 - Documentation - VMware
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
2 Under Adapter Details, click the Properties tab and click Edit in the Authentication panel.<br />
3 Specify authentication method.<br />
n None<br />
n Use unidirectional CHAP if required by target<br />
n Use unidirectional CHAP unless prohibited by target<br />
n Use unidirectional CHAP<br />
n Use bidirectional CHAP. To configure bidirectional CHAP, you must select this option.<br />
4 Specify the outgoing CHAP name.<br />
Make sure that the name you specify matches the name configured on the storage side.<br />
n To set the CHAP name to the iSCSI adapter name, select Use initiator name.<br />
n To set the CHAP name to anything other than the iSCSI initiator name, deselect Use initiator name<br />
and type a name in the Name text box.<br />
5 Enter an outgoing CHAP secret to be used as part of authentication. Use the same secret that you enter<br />
on the storage side.<br />
6 If configuring bidirectional CHAP, specify incoming CHAP credentials.<br />
Make sure to use different secrets for the outgoing and incoming CHAP.<br />
7 Click OK.<br />
8 Rescan the iSCSI adapter.<br />
If you change the CHAP parameters, they are used for new iSCSI sessions. For existing sessions, new settings<br />
are not used until you log out and log in again.<br />
Set Up CHAP for Target in the <strong>vSphere</strong> Client<br />
For software and dependent hardware iSCSI adapters, you can configure different CHAP credentials for each<br />
discovery address or static target.<br />
When configuring CHAP parameters, make sure that they match the parameters on the storage side. The CHAP<br />
name should not exceed 511 and the CHAP secret 255 alphanumeric characters.<br />
Required privilege: Host.Configuration.<strong>Storage</strong> Partition Configuration<br />
Prerequisites<br />
Before setting up CHAP parameters for software and dependent hardware iSCSI, determine whether to<br />
configure one-way or mutual CHAP.<br />
n In one-way CHAP, the target authenticates the initiator.<br />
n In mutual CHAP, both the target and initiator authenticate each other. Make sure to use different secrets<br />
for CHAP and mutual CHAP.<br />
Procedure<br />
1 Access the iSCSI Initiator Properties dialog box.<br />
2 Select either Dynamic Discovery tab or Static Discovery tab.<br />
Chapter 11 Configuring iSCSI Adapters and <strong>Storage</strong><br />
3 From the list of available targets, select a target you want to configure and click Settings > CHAP.<br />
<strong>VMware</strong>, Inc. 105