(SYSLIB) Programming Reference Manual - Public Support Login ...

SAR$ WRITE
Table 18–6. SAR$: WRITE Procedure SW$CALLST Codes
Octal Code Status
0100 An unrecognized error has occurred in the SDFO routine. The SDFO error
code is returned in the SUB_STATUS field.
0101 An unrecognized error has occurred in an ACD subroutine. The ACD error
code is returned in the SUB_STATUS field.
0102 An unrecognized error has occurred in executing ER SYMB$. The SYMB$
error code is returned in the SUB_STATUS field.
0103 An incorrect SDFO packet version is being used. The correct SDFO packet
version is returned in the SUB_STATUS field.
0104 An incorrect ER SYMB$ packet version is being used. The correct SYMB$
packet version is returned in the SUB_STATUS field.
A SW$CALLST code of 0100 or greater is a SAR$ internal error.
The WRITE procedure I/O status codes listed in Table 18–7 may be returned to the
calling program in the SW$IOSTAT field of the WRITE packet.
Table 18–7. SAR$: WRITE Procedure SW$IOSTAT Status List
Octal Code Status
0 Normal I/O status.
01 to 040 See the Exec ER Programming Reference Manual for an explanation of the
I/O status codes.
18.3. WRITE Function Supported Character Set
Types
Table H–1 lists 64 character set types defined for the OS 2200 system. Forty of these
are referred to as ASCII-like. This means that the character set is essentially identical to
the ASCII/ISO character set in the octal range 000 through 0177, with any differences
being minor. Table H–1 identifies the character set types that are ASCII-like.
Throughout this section, wherever ASCII or ASCII/ISO is used, the SAR$ capabilities
apply equally to all ASCII-like character sets.
The following character set types may be written to output files:
• ASCII-like characters, including ASCII/ISO 9-bit characters and ASCII/ISO 9-bit
characters with embedded shift-coded kanji
• Attributed character data (ACD)
18–34 7833 1733–004