2391 Cutting Layouts General Directions - PrintSew

English
2391
1
8
10
12
14
7
11
4 / 4
9
13
2
© Copyright 2010—Simplicity Pattern Co., Inc. / Printed in U.S.A. / Simplicity is a registered trademark of Simplicity Pattern Co., Inc.
STRAP
BAG FACING
BACK
FRONT AND
BACK
7. On OUTSIDE, pin closed zipper to bag front, placing zipper
face down, having long edges even and tab end of zipper
tape even with side edge (edge with large dot).
Using an adjustable zipper foot, machine-stitch zipper in
place along seam line as far as small dot; back-stitch at small
dot to reinforce seam. Zipper extends approximately 3-1/4"
(8.3cm) beyond side edge of bag. (Zipper will be adjusted
later.)
8. Stitch remaining half of zipper to bag back in same manner.
Open out bag; press, pressing under 1/4" (6mm) on
remaining raw edge of bag front and back at end of zipper
extension.
9. Cut a piece of ribbon 14" (35.5cm) long for handle. Fold
ribbon in half and on OUTSIDE, pin ribbon to bag front at
large dot, having raw edges even. Baste.
10. With RIGHT sides together, stitch bag front to back at side
and lower edges, leaving the corners free.
11. To form corners, fold corner, matching seams. Stitch seam.
12. Stitch seams of bag facing same as for bag. Press under 1/4"
(6mm) on upper edge of bag facing.
13. Turn bag facing RIGHT side out. Press.
With WRONG sides together, pin facing to bag, matching
seams. Slip-stitch pressed edge of facing over zipper tape.
14. Turn bag RIGHT side out. Place a pin on zipper extension 1"
(2.5cm) beyond side seam. Sew several overcast stitches
across zipper teeth at pin. Trim away lower end of zipper
close to stitching.
Cut a piece of ribbon 3" (7.5cm) long. Wrap ribbon around
adjusted end of zipper, turning under and lapping one end of
ribbon. Stitch close to both edges of ribbon.
BAG H
CUTTING INSTRUCTIONS
1. Cut pillowcase apart along side edges.
2. Open out pillow case so it measures 60” (153cm) long and
22” (56cm) wide. For bag front and back, pin pattern tissue to
RIGHT side of pillowcase front over embroidery or design,
placing lower edge along lower edge of pillowcase.
For bag facing, pin pattern to RIGHT side of pillowcase
slightly above bag front and back. Pin strap to pillowcase, as
shown.
Cut out bag along side and upper edges. Cut out facing and
strap as shown.
9
5
3
11
13
7
8
14
4
6
12
10
SEWING DIRECTIONS
NOTE: Bag is stitched in 1/4" (6mm) seams.
3. Fold bag in half, with RIGHT sides together, having raw
edges even. Stitch side seam.
4. Turn bag RIGHT side out. Pin lower edges of bag together.
Stitch along lower edge. Press.
5. Fold bag strap in half, lengthwise with WRONG sides
together. Press, setting in a crease.
6. Open out long edges of strap and turn them to WRONG side
so that they meet at the crease. Press.
7. Fold strap in half lengthwise, bringing pressed edges
together. Stitch close to both long edges.
8. On OUTSIDE, pin strap to upper edge of bag, centering ends
over side seam and small dot. Baste.
9. Pin fleece to WRONG side of bag facing, having raw edges
even. Baste close to raw edges.
10. Fold bag facing in half, with RIGHT sides together. Stitch
seam.
11. Bring seam to center and stitch across lower edge, leaving an
opening to turn.
12. With RIGHT sides together, pin facing to bag at upper edge,
matching centers. Stitch seam.
13. Turn bag RIGHT side out. Slip-stitch opening edges of facing
together. Insert bag facing into bag; press.
14. On OUTSIDE, pin ribbon to upper edge of bag, turning under
and lapping one end at side seam. Stitch close to long edges
of ribbon.