8-Port H323/SIP VoIP Gateway
8-Port H323/SIP VoIP Gateway 8-Port H323/SIP VoIP Gateway
4.2.5.6 Gain /VoIP Setup/Advance Setup/Gain This page defines different function gain on the gateway. Gain when Dial tone phase: When phone off hook, user will hear the dial tone generated from the gateway, sser can adjust the play/record gain during this phase for stable DTMF detection. After connection, the gains setting here is no use, the gateway will adjust the gain setting on /Line Configure/Line setting/ Play: Transmit gain from network to line. Adjust the speaker volume on the handset. Higher value will louder the speaker on local side. Record: Receive gain from line to network. Adjust the microphone volume on the handset. Larger value which will amplifier the MIC volume on local site. Incorrect value will cause the gateway can not receive the DTMF user pressed on phone set, please use the default 0dB if no other issue. DTMF Generate DSP play Gain [-29~3] Setting the internal gain used by DSP for generate the DTMF signal, incorrect value will cause the DTMF can not accept by other telephone equipment. Please use the default value if no other issue. Call progress Tone DSP play Gain[-31~0] Setting the internal gain used by DSP for generate the CPT ( Call Progress Tone), Incorrect value will cause the DTMF can not accept by other telephone equipment. Please use the default value if no other issue. Caller ID Detection record Gain [13~-3] Setting the Caller ID Receiver gain. Incorrect value will cause the Caller ID signal can not be receive, please use the default value if no other issue. 68
4.2.5.7 QoS /VoIP Setup/Advance Setup/QoS User can define the ToS field on the VoIP packet for Quality of Service control. The ToS field is included these 2 parameters: Precedence: bit 0,1,2 DSCP(Diffserv Code Point): bit 3~7 User can select input either IP Precedence or DSCP value. Or input the ToS binary code directly. 69
- Page 17 and 18: 4.2.2 VoIP Function 4.4.2.1 VoIP Se
- Page 19 and 20: 4.2.2.2 VoIP/Line Configure/ Line S
- Page 21 and 22: 4.2.2.3 Line configure/ Tone Settin
- Page 23 and 24: 4.2.2.4 Line configure/ Line Featur
- Page 25 and 26: Line number Priority: The 1 st line
- Page 27 and 28: 4.2.2.6 Routing Setup/ VoIP Call Ou
- Page 29 and 30: . Remark: Remark for this routing r
- Page 31 and 32: user press the number is 8862123456
- Page 33 and 34: Port Message Display Port Type Stat
- Page 35 and 36: 1 Via_GK2 1 gk2 33Delete 2 GK2_3_1
- Page 37 and 38: 4.2.2.7 VoIP Call In Routing Table
- Page 39 and 40: Index Area Code Strip Prefix Maximu
- Page 41 and 42: Enable: During Talk, you can answer
- Page 43 and 44: 10.1.1.1/104, it mean it will forwa
- Page 45 and 46: A. Time & Digits wait for user The
- Page 47 and 48: 4.2.2.9 VoIP Routing Profile Settin
- Page 49 and 50: Please remember to press the modify
- Page 51 and 52: f. No Answer Sec. Defined the wait
- Page 53 and 54: 1.4.2.11 VoIP Authorization Setting
- Page 55 and 56: 4.2.3.2 Setup the Register Server
- Page 57 and 58: q. Conference ID: Some SIP Server r
- Page 59 and 60: FXO: Analog phone interface for con
- Page 61 and 62: It will indicate the status of link
- Page 63 and 64: 4.2.5.2 Listen Port /VoIP Setup/Adv
- Page 65 and 66: Silence Detection / Suppression: En
- Page 67: 4.2.5.5 Flash & Call waiting /VoIP
- Page 71 and 72: 4.2.5.9 FoIP /VoIP Setup/Advance Se
- Page 73 and 74: Prompt voice for replace dial tone:
- Page 75 and 76: 4.2.6.2 Telnet & SNMP /VoIP Setup/A
- Page 77 and 78: the most update information. Cable/
- Page 79 and 80: LAN MAC Address Short for Media Acc
- Page 81 and 82: 1.2.7.3 Date & Time This page is us
- Page 83 and 84: 1.2.7.5 System Log The system log p
- Page 85 and 86: 4.2.8 Route Function(/System Setup)
- Page 87 and 88: Subnet Mask Set the subnet mask of
- Page 89 and 90: dropped. D. DNS This page sets the
- Page 91 and 92: IP Pool Ending Address The ending a
- Page 93 and 94: 4.2.8.3 NAT Virtual Server This is
- Page 95 and 96: The Port Mapping page does a port r
- Page 97 and 98: DMZ Check this item to enable DMZ s
- Page 99 and 100: scans all the TCP/UDP port of a sta
- Page 101 and 102: URL Filtering Enable URL Filter Che
- Page 103 and 104: 4.2.8.5 Routing Routing Table This
- Page 105 and 106: 4.2.8.6 UPnP Settings UPnP Enable U
- Page 107 and 108: 4.2.8.7 DDNS Enabled Check this ite
- Page 109 and 110: 4.2.9.2 VoIP Module /System Mainten
- Page 111: 4.2.10 Save Modification /Save Modi
4.2.5.7 QoS<br />
/<strong>VoIP</strong> Setup/Advance Setup/QoS<br />
User can define the ToS field on the <strong>VoIP</strong> packet for Quality of Service control.<br />
The ToS field is included these 2 parameters:<br />
Precedence: bit 0,1,2<br />
DSCP(Diffserv Code Point): bit 3~7<br />
User can select input either IP Precedence or DSCP value. Or input the ToS<br />
binary code directly.<br />
69