8-Port H323/SIP VoIP Gateway
8-Port H323/SIP VoIP Gateway 8-Port H323/SIP VoIP Gateway
Out: There is a phone call made from Network VoIP and pick up by phone set. e. Connected IP: The remotely party IP of this VoIP call. f. Caller ID: Caller ID received from telephone line port. g. Start Time: Date & time of this VoIP call begin on this port. h. End Time: Date & Time of last VoIP call End on this port. i. Talking Sec: Total talked seconds of last VoIP call on this port. j. Dialed number: On the VoIP call out (line status display “In”). This will display the real dial out number for VoIP call. On the VoIP call in (line status display “Out”). This will display the number will dial out to phone line. Release by: This will display the reason of this call termination. B.Error Message For some reason,(ex. All lines of this VoIP Gateway are busy) here will display the failure information about the last failure VoIP Call. 18
4.2.2.2 VoIP/Line Configure/ Line Setting /VoIP Setup/Line Configure/Line Setting/ This page will setup the phone line information each port. a. Port: display the port number, e.g. 1 or 2. b. Interface: Telephone interface type: FXO: for connect to telephone line or PBX extension line. FXS: for connect to regulate phone set a. Name: Line name for this port. This will send and display on the remote side during VoIP call b. Line number: Telephone number assigned to this line. c. TxGain: Transmitter Gain. This will adjust the speaker volume of local phone set. The adjust range is from +3 to -13dB. Higher value will cause louder sound come from local phone set. d. RxGain: Receiver Gain. This will adjust the microphone volume of local phone set. The adjust range is from -3 to +13dB. Higher value will increase amplifier the sound get from local phone set. e. Inbound: Enable or disable the VoIP call to Internet. Disable the inbound option will not allow any call made from phone set to Internet. f. Outbound: Enable or disable the VoIP call from Internet. Disable the Outbound option will not allow any call made from Internet to phone set. g. Hotline: When Enable, it will allow you to make a VoIP call without Press any number. That mean it will direct call out by VoIP when you off hook the phone of this line. For example, if you want line 1 to become a hot line for VoIP call, every time 19
- Page 1 and 2: VOI-8001 VOI-8002 VOI-8003 8-Port H
- Page 3 and 4: Chapter 1. Introduction 1.1 Overvie
- Page 5 and 6: Chapter 2 Getting Started 2.1 Front
- Page 7 and 8: Chapter 3 Configuration The default
- Page 9 and 10: To use PPPoE ADSL connection, pleas
- Page 11 and 12: 3.3 Register Server If this VoIP Ga
- Page 13 and 14: IP address, for example: 168.56.9.2
- Page 15 and 16: 4.2 Web UI Management The VoIP Gate
- Page 17: 4.2.2 VoIP Function 4.4.2.1 VoIP Se
- Page 21 and 22: 4.2.2.3 Line configure/ Tone Settin
- Page 23 and 24: 4.2.2.4 Line configure/ Line Featur
- Page 25 and 26: Line number Priority: The 1 st line
- Page 27 and 28: 4.2.2.6 Routing Setup/ VoIP Call Ou
- Page 29 and 30: . Remark: Remark for this routing r
- Page 31 and 32: user press the number is 8862123456
- Page 33 and 34: Port Message Display Port Type Stat
- Page 35 and 36: 1 Via_GK2 1 gk2 33Delete 2 GK2_3_1
- Page 37 and 38: 4.2.2.7 VoIP Call In Routing Table
- Page 39 and 40: Index Area Code Strip Prefix Maximu
- Page 41 and 42: Enable: During Talk, you can answer
- Page 43 and 44: 10.1.1.1/104, it mean it will forwa
- Page 45 and 46: A. Time & Digits wait for user The
- Page 47 and 48: 4.2.2.9 VoIP Routing Profile Settin
- Page 49 and 50: Please remember to press the modify
- Page 51 and 52: f. No Answer Sec. Defined the wait
- Page 53 and 54: 1.4.2.11 VoIP Authorization Setting
- Page 55 and 56: 4.2.3.2 Setup the Register Server
- Page 57 and 58: q. Conference ID: Some SIP Server r
- Page 59 and 60: FXO: Analog phone interface for con
- Page 61 and 62: It will indicate the status of link
- Page 63 and 64: 4.2.5.2 Listen Port /VoIP Setup/Adv
- Page 65 and 66: Silence Detection / Suppression: En
- Page 67 and 68: 4.2.5.5 Flash & Call waiting /VoIP
4.2.2.2 <strong>VoIP</strong>/Line Configure/ Line Setting<br />
/<strong>VoIP</strong> Setup/Line Configure/Line Setting/<br />
This page will setup the phone line information each port.<br />
a. <strong>Port</strong>: display the port number, e.g. 1 or 2.<br />
b. Interface: Telephone interface type:<br />
FXO: for connect to telephone line or PBX extension line.<br />
FXS: for connect to regulate phone set<br />
a. Name: Line name for this port. This will send and display on the remote<br />
side during <strong>VoIP</strong> call<br />
b. Line number: Telephone number assigned to this line.<br />
c. TxGain: Transmitter Gain. This will adjust the speaker volume of local<br />
phone set. The adjust range is from +3 to -13dB. Higher value will cause<br />
louder sound come from local phone set.<br />
d. RxGain: Receiver Gain. This will adjust the microphone volume of local<br />
phone set. The adjust range is from -3 to +13dB. Higher value will increase<br />
amplifier the sound get from local phone set.<br />
e. Inbound: Enable or disable the <strong>VoIP</strong> call to Internet. Disable the inbound<br />
option will not allow any call made from phone set to Internet.<br />
f. Outbound: Enable or disable the <strong>VoIP</strong> call from Internet. Disable the<br />
Outbound option will not allow any call made from Internet to phone set.<br />
g. Hotline: When Enable, it will allow you to make a <strong>VoIP</strong> call without Press<br />
any number. That mean it will direct call out by <strong>VoIP</strong> when you off hook the<br />
phone of this line.<br />
For example, if you want line 1 to become a hot line for <strong>VoIP</strong> call, every time<br />
19