Contents, cont'd. - Intermec

CUT ON/OFF
Chapter 2 Program Instructions
Field of Application Statement enabling or disabling automatic cutting after PRINTFEED
execution and optionally adjusting the paper feed before and after the
cutting.
Syntax CUT [] ON|OFF
is optionally the amount of paper to be fed out before cutting
and pulled back after cutting.
Default: CUT OFF
Remarks This statement makes it possible to enable or disable automatic execution of
a CUT operation directly after the execution of each PRINTFEED statement.
If any extra paper feed in connection with the cutting operation is required,
use startadjust and stopadjust setup or specify the desired amount of paper to
be be fed out before the cutting is performed and pulled back afterwards in
the CUT ON statement.
Example This program enables automatic cutting and orders the printer to print a text
and feed out an extra amount of strip before cutting the web. The paper is then
pulled back the same distance:
10 CUT 280 ON
20 PRPOS 250,250
30 DIR 1
40 ALIGN 4
50 FONT "Swiss 721 BT"
60 PRTXT "Hello everybody!"
70
RUN
PRINTFEED
Intermec Fingerprint 7.2 – Reference Manual Ed. 3 54