Contents, cont'd. - Intermec

SYSVAR
Chapter 2 Program Instructions
Field of Application System array for reading or setting various system variables.
Syntax SYSVAR()
is the reference number of the system variable:
0 Not intended for public use
1 Not intended for public use
2 Not implemented
3 Not intended for public use
4 Not implemented
5 Not implemented
6 Not implemented
7 Not implemented
8 Not implemented
9 Reserved special applications
10 Reserved special applications
11 Reserved special applications
12 Not implemented
13 Read ribbon counter
14 Read errors since power on
15 Read errors since last SYSVAR(15)
16 Read number of bytes received at execution of a
STORE or STORE INPUT statement
17 Read number of frames received at execution of a
STORE or STORE INPUT statement
18 Read or Set verbosity level
19 Read or Set type of error message
20 Read direct or transfer mode
21 Read printhead density (dots/mm)
22 Read number of printhead dots
23 Read status of transfer ribbon sensor
24 Read if new startup has been performed since last
SYSVAR(24)
25 Read or Set type of Centronics communication
28 Set paper feed data erase at headlift
29 Read DTR condition on "uart2:"
30 Read DTR condition on "uart3:"
31 Read last sent ACK, NAK, or CAN character in the
MUSE protocol.
32 Read odometer value
33 Read DTR condition on "uart1:"
34 Read or Set positioning mode for TrueType
characters
Intermec Fingerprint 7.2 – Reference Manual Ed. 3 221