Contents, cont'd. - Intermec

BARFONT (BF)
Chapter 2 Program Instructions
Field of Application Statement specifying fonts for the printing of bar code interpretation.
Syntax BARFONT|BF[#,][,[,[,[,[,
[,]]]]][ON]
# is, optionally, the start parameter in the syntax above.
is the name of the font selected for bar code interpretations.
is the height in points of the font.
is the clockwise slant in degrees (0-90°).
is the distance in dots between bar code and bar font.
is the magnification in regard of height.
is the magnification in regard of width.
nexp 6 > is the width enlargement in percent relative the height (1–
1000). Default: 100. Does not work with bitmap fonts.
ON optionally enables the printing of bar code interpretation.
Reset to default by: PRINTFEED execution.
Remarks Start Parameter:
The start parameter specifies which parameter in the syntax above should be
the first parameter in the statement. Thereby you may bypass some of the
initial parameters.
Default value: #1
Font Name:
This parameter corresponds to the FONT statement, but will only affect bar
code interpretation. Double-byte fonts cannot be used.
Default : Swiss 721 BT
Font Size:
This parameter corresponds to the FONT statement, but will only affect bar
code interpretation. The size is measured in points (1 point = 1/72 inch ≈ 0.352
mm).
Default : 12
Font Slant:
This parameter corresponds to the FONT statement, but will only affect bar
code interpretation. Slanting increases clockwise. Values greater that 65–70°
will be unreadable.
Default : 0
Vertical Offset:
The distance between the bottom of the bar code pattern and the top of the
character cell is given as a number of dots.
Default value: 6
Intermec Fingerprint 7.2 – Reference Manual Ed. 3 18