Contents, cont'd. - Intermec

LBLCOND
Field of Application Statement for overriding the paper feed setup.
Syntax LBLCOND,
Chapter 2 Program Instructions
specifies the type of action:
0 = Overriding the stop adjust.
1 = Overriding the start adjust.
2 =Turning off the LSS or Black Mark Sensor.
specifies as a number of dots.
Remarks This instruction allows you to override the printer's feed-adjust setup or to
temporarily turn off the label stop or black mark sensor:
= 0 temporarily sets the stop adjust to the value specified
1
by . 2
= 1 temporarily sets the start adjust to the value specified
1
by . 2
= 2 makes the label stop sensor (LSS) or black mark
1
sensor temporarily ignore any gaps or marks detected
within the length of paper feed specified by . 2
This allows the use of labels of such shapes that would
make the LSS react prematurely, or tickets with preprint
at the back of the paper that would interfere with the
detection of the black mark.
Verifying a start adjust or stop adjust value in the Setup Mode by pressing key
No. 16 (normally labelled “Enter”), or setting the value by means of a setup
file, will revoke any LBLCOND statement for the parameter in question.
The label stop sensor will be returned to normal operation by the statement:
LBLCOND 2,0
All current LBLCOND statements will be revoked at startup or the execution
of a REBOOT statement, i.e. start and stop adjust will be decided by the setup
and the label stop sensor will work normally.
Example In this example, the start adjust value in the setup mode is overridden and the
label stop sensor is set to ignore any gaps in the web within 20 mm (240 dots
at 12 dots/mm) of paper feed:
10 LBLCOND 1,5: LBLCOND 2,240
20 FONT "Swiss 721 BT"
30 PRTXT "Hello"
40 PRINTFEED
Intermec Fingerprint 7.2 – Reference Manual Ed. 3 129