Contents, cont'd. - Intermec

LAYOUT, cont'd.
Remarks, cont'd. Logotype name file format #1:
(no embedded spaces in name)
Record 1–n, 10 bytes each.
C ...C 1 10
. . .
. . .
: Name for logotype No. 1
C ...C 1 10 : Name for logotype No. n
Logotype name file format #2:
(Records sorted in ascending logotype number order)
Record 1-n, 13 bytes each.
DD : Logotype number (2 digits)
C : always ":" (colon). Separator. Distinguishes format 2.
C ...C 1 10 : Name of logotype (10 characters)
Note: Logotype name file formats #1 and #2 are alternative.
Chapter 2 Program Instructions
Data array/file format:
(sorted in ascending order)
One array position/One file line.
HH : Element number
C ...C : Data
1 n
If a data element cannot be used in the layout, an error will occur and the index of the
unused element and error code -1 is placed in the error array/file.
Error array/file format:
(sorted in ascending order)
Array position/File line No. 0: Record number for error 1
Array position/File line No.1: Error number for error 1
. . .
. . .
Array position/File line No. 2n-2: Record number for error n
Array position/File line No. 2n-1: Error number for error n
Also refer to the chapter “Label Design; Layout Files” in Intermec Fingerprint
Programmer's Guide.
To improve the performance, it is strongly recommended to create the layout
and logotype name files in the printer's temporary memory ("tmp:"). Once
they have been created in "tmp:", they could be copied to the printer's
permanent memory to avoid losing them at power off.
Do not confuse this statement with the statements LAYOUT INPUT,
LAYOUT END and LAYOUT RUN, which can only be used in the Direct
Mode.
Intermec Fingerprint 7.2 – Reference Manual Ed. 3 124