9560 Transaction Manager User's Manual - Intermec

Character Set 7-9
Codabar 7-10
CODE 11 7-12
CODE 39 7-13
CODE 93 7-14
Code 128 7-15
Computer Response Required Mode (CRRM) 7-16
Data Bits 7-17
Display Setting 7-18
EOM (End of Message) 7-19
Full ASCII 7-20
Intercharacter Delay 7-21
Interface 7-22
Interleaved 2 of 5 (I 2 of 5) 7-23
IRL BAK (Bad Program Acknowledge) 7-24
IRL END (End of Program) 7-25
IRL EOF (End of File) 7-26
IRL EOP (End of Program Block) 7-27
IRL EOR (End of Record) 7-28
IRL PAK (Program Acknowledge) 7-29
IRL PSS (Program Statement Separator) 7-30
IRL RUN 7-31
IRL SOP (Start of Program Block) 7-32
Katakana 7-33
LRC (Longitudinal Redundancy Check) 7-36
NEG (Negative Acknowledgment) 7-37
Parity 7-38
POL (Poll) 7-39
Preamble A Required 7-40
Protocol 7-41
Records per Block 7-42
REQ (Request for Acknowledgment) 7-43
RES (Reset) 7-44
Resume IRL 7-45
Scanner Timeout 7-46
Scanner Operation 7-47
SEL (Select) 7-48
Select Terminal Mode 7-49
SOM (Start of Message) 7-50
Stop Bits 7-51
Trigger Event 7-52
Time in Seconds 7-53
Timeout Delay 7-54
Turnaround Delay 7-55
Contents
ix