9560 Transaction Manager User's Manual - Intermec

Status Beeps
Error Status Beeps
Beeps Error Condition
The reader beeps to indicate its status and condition.
10
Troubleshooting
4 low Power was applied or unit was reset. RAM and ROM are in proper working
condition.
high low high An input or output error occurred.
1 low A valid label was read, but not transmitted to the host.
3 low Invalid data or an invalid command.
Clear command was sent when the buffer was already empty.
The buffer is full; more than 25 characters in regular operation or 128 characters in
Accumulate mode.
The CAPS key was pressed.
Adjusting the Beep Volume
To adjust the beep volume:
Scan the Raise or Lower Beep Volume labels.
Lower Beep Volume
*$+BV8$-*
*$+BV8$-*
Raise Beep Volume
*$+BV9$-*
*$+BV9$-*
10-5