9560 Transaction Manager User's Manual - Intermec

9560 Transaction Manager User’s Manual
Exiting from Program Edit Mode
9-6
Input the Command To Exit Without Compiling To Exit and Compile
From the host or scanner 1. Press Enter at the beginning of a
new line. The editor prompt is
displayed.
2. Send the /$ command or scan the
Exit IRL Editor command label.
Exit IRL Editor
*/$*
*/$*
From the 9560 keypad 1. Press Enter at the beginning of a
new line. The editor prompt is
displayed.
2. Press Q at the editor prompt.
3. Press Enter.
Creating and Running IRL Programs
1. Exit IRL without compiling.
2. Send the E command or
scan the Compile IRL
Program label.
Compile IRL Program
*E*
*E*
1. Press Enter at the beginning
of a new line. The editor
prompt is displayed.
2. Press E at the editor
prompt.
3. Press Enter.
For a complete listing of the IRL program commands, refer to the IRL
Programming Reference Manual (Intermec Part No. 048609). This section presents
only those commands necessary to start, stop, and edit an IRL program.
Inserting a Program Statement
Use the Insert command to enter program statements. This command displays
the next available line number. If you type a program statement followed by
Enter, the statement is added and a new line is displayed.
To enter program statements
1. Enter the I command or scan the Insert Program Statement command label.
Insert Program Statement
*I*
*I*
2. Type the program statement and then press Enter.