9560 Transaction Manager User's Manual - Intermec

9560 Transaction Manager User’s Manual
IRL Editor
9-4
You use the IRL editor to develop, input, and edit IRL programs on the reader
or on a terminal attached to the reader. The IRL editor has two modes:
Command Line mode and Program Edit mode.
In Command Line mode the editor accepts any of the commands listed in the
following table. If you enter an invalid editor command, the editor displays an
error message. For complete information on using the IRL editor, refer to the
IRL Programming Reference Manual.
IRL Editor Commands
Command Description
D Delete line
E End (and compile)
F Find
I Insert line
L List
M Enter Monitor
Q Quit
S Substitute
U Usage
Enter Exit Program Edit mode (when typed at the beginning of a new line)
You enter Program Edit mode by using any command that edits your program,
such as I (Insert). In Program Edit mode the editor displays a program line for
you to edit. You can enter valid and invalid IRL statements. The statements are
not checked until you compile the program.
Using the Editor
To enter the IRL editor
• Enter the $$ command, press Ctrl I, or scan the Enter IRL Editor command
label.
Enter IRL Editor
*$$*
*$$*