9560 Transaction Manager User's Manual - Intermec

Data Entry Commands - LED/Relay Control
LED/Relay Control
Purpose: Controls the four status LEDs of an attached 9191 Digital Wand Station and
the three internal relays of the 9560. Also returns the status of the sense
inputs to the #0 register. You can enter up to eight valid data characters. This
command is specific to the 9560.
Terminal /
Keyboard
8-22
Valid data characters are:
0 = turn LED/relay off
1 = turn LED/relay on
X = default LED function or no change to current state
The command syntax is:
$%char1 char2...char8
Character LED/Relay
1st Configuration LED
2nd Fault LED
3rd Wait LED
4th Good Read LED
5th 1st relay
6th 2nd relay
7th 3rd relay
8th Reserved
The relays retain their states from the last LED/Relay command until the
next LED/Relay command. A power on or off reset turns the relays off and
they stay off until an LED/Relay Control command turns them on.
When the LED/Relay Control command is executed, the status of the sense
inputs is returned to the #0 register. For more information, see “9560-Unique
IRL Commands” in Chapter 9, “Interactive Reader Language.”
Not Applicable
Host: $%dataX